Fronius Datamanager Network Configuration; General; Requirements - Fronius Datamanager Bedienungsanleitung

Fronius Datamanager network configuration

General

The network configuration function patented by Fronius enables Fronius Datamanager to:
-
-
-

Requirements

If Fronius Datamanager is being integrated into an existing network, the Fronius Dataman-
ager address must be adapted to the network.
Example: Network address range = 192.168.1.x, subnet mask = 255.255.255.0
-
-
-
If Fronius Datamanager will be sending service messages and/or data to Fronius So-
lar.web, then a gateway address and a DNS server address must also be entered. Fronius
Datamanager uses the gateway address to access the Internet. The IP address of the DSL
router can be used as a gateway address, for example.
IMPORTANT!
-
-
If you are using the WLAN network connection, the Fronius Datamanager must be
equipped with a WLAN function and a WLAN antenna suitable for the inverter.
Fronius Dataman- The Fronius Datamanager network configuration comprises the following steps:
ager network con- -
figuration
-
-
-
92
Establish an easy connection between Fronius Datamanager and the PC/laptop
make settings
display important system data
NOTE! Configuring a network for Fronius Datamanager requires knowledge of
network technology.
An IP address between 192.168.1.1 and 192.168.1.254 must be assigned to Fronius
Datamanager.
The IP address selected may not be already assigned in the network.
The subnet mask must correspond to the existing network (e.g. 255.255.255.0).
Fronius Datamanager may not have the same IP address as the PC/laptop!
Fronius Datamanager cannot connect to the Internet spontaneously. A router must be
used for a DSL connection to the Internet.
Starting up Fronius Datamanager and accessing the Fronius Datamanager web inter-
face
Entering network data
Configuring Fronius Datamanager for the WLAN connection
Setting the IP address and connecting Fronius Datamanager to the network