Fronius Datamanager Bedienungsanleitung Seite 81

No. Function
(1) Jumper IP Address
Used for switching to the default IP address 169.254.0.180 (only relevant for
LAN)
Fronius Datamanager uses the fixed IP address 169.254.0.180;
the fixed IP address is used for a direct connection to a PC without first having
to pre-configure the PC.
(2) Supply LED
- lights up green: When sufficient power is coming from Fronius Solar Net;
Fronius Datamanager is operational
- does not light up: When no power or not enough power is coming from Fro-
nius Solar Net; an external power supply is required
- flashes red: During an update process
IMPORTANT! Do not interrupt the power supply while updating.
- lights up red: the update process failed
(3) Connection LED
- lights up green: When there is an active connection within Fronius Solar
Net
- lights up green: When there is an interrupted connection within Fronius So-
lar Net
(4) WLAN LED
- lights up green: When there is an existing network connection
- lights up red: When there is no existing network connection
- does not light up: Plug-in card without WLAN
(5) Solar Web LED connection
- lights up green: When there is an existing connection to Fronius Solar.web
- lights up red: When there is no connection to Fronius Solar.web, but one is
required
- does not light up: When no connection to Fronius Solar.web is required
(6) LAN connection
Ethernet interface colored blue for connecting an Ethernet cable
(7) I/Os + Mating Connector
provided for future upgrades
IMPORTANT! The I/Os are not yet supported by any software. Nothing may be
connected to the I/Os until further notice is given.
(8) WLAN Antenna Socket (only for versions with WLAN)
Used for connecting the WLAN antenna of the WLAN antenna extension cable
(9) Solar Net IN connection
'Fronius Solar Net' input colored red for connecting other DATCOM compo-
nents (e.g. inverters, sensor cards)
79