Bpreparing Device For Operation; System Components - SAFEX FlowMarker II Gebrauchsanleitung

or by means of different probes, fog screens, etc. into difficult places or in a special way
into air-flows, machinery etc. (See for this section „G" OPTIONAL ACCESSORIES).
The FlowMarker basic equipment consists of:

®
FlowMarker
the -Device

one Plug-in Battery (12V, 2.0Ah/20HR, type LC-TA122PU)

one unscrewable Fog Application

one pressurized aerosol-can

5 Condensation Absorbing Rings,
tube)

one Plastic Tube for removing condensation absorbing ring KR3

a low voltage POWER SUPPLY 12 V =
the battery inside the device, together with 4 international wall outlet adapters

the User Manual

®
FlowMarker
and the
PREPARING DEVICE FOR OPERATION
B
Before first use, check the device together with its accessories (carrying case content)
with regard to intactness and completeness
any damages or missing parts to the supplier or the supplier's service office.
®
The FlowMarker is delivered de-aerated and
fog fluid for a quick starting test.
a. Place the fog fluid aerosol can upright on a solid base. Remove the valve protection
cap. Hold the can with one hand. (A filling is possible only with the
(stem) pointing vertically upwards,
the can!)
b. Hold the FlowMarker
opening at the back of the device onto the
hold the device upright, with the
c. Press the can slightly against the device to inject the fog fluid from the can into the
device.
Important: No dust or dirt particles must get into the fill opening.
d. The filling procedure is visible in the tank control window. The tank piston with the
yellow mark moves towards the back of the device.
The filling procedure
along 80 % of the window
overfill the tank under any circumstances!
e. Pull the valve stem out of the fill opening. Put the valve protecting cap onto the can.
Prevent filling parts from getting dirty!
f. Remove possible fluid remainders from the fill opening with a paper towel.
FOG FLUID is non-toxic and harmless and bears no hazards.)
itself,
Tube, type AR1
®
FlowMarker -Fog Fluid
each type KR3 and KR2 (two in the application
(1 A, 100 - 240 V ≈ ↔12 VA =) for charging
-Carrying Case with compartments.
of the standard parts.
with the tank approximately half full
but not in horizontal or another position of
®
by its handle, with the fog outlet pointing up. Fit the fill
valve stem of the can.
tank control window being visible.
has to be stopped when the yellow mark has moved
*,
respectively has reached its red zone.
(fogging agent)
Immediately report
of
valve pin
Make sure to
Do not
®
(SAFEX
GAFM-II-10.12 • 34
SYSTEM
COMPONENTS
GENERAL
FILLING OPERATION
*
/ 8