SAFEX FlowMarker II Gebrauchsanleitung Seite 18

17 /
34 • GAFM-II-10.12
SLIP HAZARD
Do not blow fog on hot surfaces, into open flames or into glowing heating ele-
ments etc.!
The normally non-flammable and non-toxic fog can decompose on hot, red glowing sur-
faces (> 380°C) or in open flames.
Heat sources like lamps, central heating or other closed heating systems or electric ma-
chines without red-glowing parts or small flames like candles, laboratory burner etc.
no hazard and need not to be given attention.
Use the FlowMarker
it in water. Any dirtying with aggressive media, dust, solvent, etc. may cause serious
damage.
The FlowMarker is not suitable for use in explosive environment. It has no EX
protection. Never use it in close proximity to open containers with inflammable
liquids or in saturated areas with fumes of inflammable liquids or gases.
Due to physical processes, longer or improper use will inevitably result in some
condensing inside the application tube.
The condensed fluid can easily be wiped off with a paper towel or washed off with water.
Remove fluid drops or spilled fluid on the ground, as viscous fluids create a risk of skid-
ding.
Fluid absorbent rings
application tube.
The larger
tube until it fits
The smaller
has completely slipped in.
The rings will absorb possible fluid condensation. They have to be replaced periodically
dependent on how intensive the device is used.
FLUID CAN The SAFEX
inflammable, non-toxic and environmentally safe.
The pressurized fog fluid can,
50°C, opened by force, or burned.
When entirely empty, dispose of it with domestic refuse.
BATTERY The battery of the
dispose of it according to local regulations!

By no means open or burn the battery, or short-circuit the battery poles.

Should, in case of damage, any acid gel escape from the battery, immediate-
ly rinse the affected parts of the body with ample water. If eyes are affected,
rinse first, then immediately consult a physician.
Before use, check the battery safety screw
chapter B „Inserting Battery).
For unattended transport, take the battery out of the device.
contacts from being short-circuited by conductive materials.
transport cover battery contacts with non-conductive material (e. g. insulating tape)
®
only in dry condition; do not pour water over the device or immerse
are available as accessory. They are inserted on both ends of the
ring KR2 has to be inserted from the „threaded" side
behind the air inlet holes
ring KR3 has to be inserted from the muzzle side
®
FOG FLUID AEROSOL CAN
like any aerosol can, must never be heated above
®
FlowMarker is a sealed lead-acid-gel-battery. If it is no longer usable,
at the recess. It must not cover the air holes!
of the black tube until it
is under pressure. The propellant N
to prevent the battery from falling out
Prevent the battery
Serious fire hazard!
bear
fog fluid
of the application
is non-
2
(See
During