D Maintenance And Care; Battery- Monitoring - SAFEX FlowMarker II Gebrauchsanleitung

13 /
34 • GAFM-II-10.12
D MAINTENANCE AND CARE
RELEASING TANK-
MONITORING
CHARGING THE
the blue button.
With the last delete the device switches in the new (secondary) mode and is therefore
ready for use. The new mode is displayed as follows:


The device turns off automatically in secondary mode not as before after 3 minutes, but
switches first for 0.5 h in the sleep mode. To
secondary mode
extinguish permanently)
A mode change (back to the primary mode) is to maintain in the same way as previously
described and also possible only after prior turn off.
Occasionally, after prolonged non-use the tank piston of the
This is however not a real malfunction, but
PISTON
amount of fog fluid into the tank
device is to be filled.
BATTERY-
If the battery voltage decreases below
declining of the battery voltage the off-phase of the red LED is becoming even shorter
until it permanently lights at about 10 Volt.
When the battery has reached
With this signaling the user recognizes at an early stage that the battery capacity comes
to an end and in regards to its working program taking this in consideration.
The battery is charged
charging adapter
BATTERY
the inserted battery via the
be plugged into a regular
The battery is automatically charged, with the FlowMarker switched on or off.
two hours, 80% of the loading is done; after 3 hours, the battery is 100% loaded. This is
is apparent on the color change of the charger LED! For frequent use, the device should
regularly be connected to the power supply and, if possible, remain connected over night.
IMPORTANT:
inadvertently pressed, for instance by objects lying on the device.
If more than one battery is available, the device can be equipped quickly with a full load
CHANGING
battery.
BATTERY
Loosen the
showing up, and slightly beat the edge of the battery compartment on the ball of the
thumb of your open hand until the battery loosens and slides into your palm.
Then insert according to section „B" chapter INSERTING BATTERY page 9 a newly full
loaded battery.
The FlowMarker is designed for
sold by SAFEX
Flashing of the green LED indicates the
Flashing of the white LED indicates the
press the blue fog button
with the fog fluid aerosol can in the same way as the
This releases the piston and the device is working again!
9,5 V the device
regularly inside
generates the necessary DC voltage. It is connected to the device with
power input socket
100 - 240 V AC / 50-60 Hz socket.
Please make sure that during storage or transport the fog button cannot be
battery compartment safety screw,
Afterwards always screw down the battery safety screw!
operation only with original batteries.
®
are specially tested and guarantee a safe and optimal function;
secondary mode.
primary mode.
immediately turn off the device in the
quickly four times in a row!
FlowMarker
can be fixed simply by giving a small
11 V the red LED starts flashing. With further
turns off automatically.
the device. The included international mains
(see figure 3). The power supply must
hold the device upright with the nozzle
(All LED's
®
may lock itself.
After
The batteries
similar