Turning Off; Energy Saving Mode - SAFEX FlowMarker II Gebrauchsanleitung

11 /
34 • GAFM-II-10.12

TURNING OFF

ENERGY SAVING
OPERATION WITH RE-
MOTE CONTROLS
airflow to be investigated,
When the tank is full and the battery completely charged,
uously for about 21 minutes.
the device will be used only impulsively.
The FlowMarker
the device completely off at any time. For this the blue button must be pressed 4 s
UNIT
permanently. First the white LED will light up briefly, then it turns off and the red LED
displays the switching off by extinguishing itself too after a second. The unit is now
internal completely powerless,
battery.
If there are additional devices connected to the charging socket
(e. g. the FM-HYDRA-TUBE SYSTEM
separately, they
Now, it is ensured that the built-in battery will not be harmfully deep discharged. However
the battery should be charged completely before the device is not in use for very long
time, because this significantly increases the service life of the lead/gel battery.
For a as long as possible battery life the

energy saving mode.

MODE
If after activating of the device heating no fog has been produced within 2
minutes, in other words the blue button has not be pushed, the device is switching
into the energy saving mode.
This mode is decreasing the heat exchanger temperature slightly, but allows the user any
time to press the fog button again.
seconds of delay (maximum 6 seconds, depending on the length of the interruption of
use).
Is no fog is generated in this mode
into the so-called
if necessary inserted wireless or cable remote controls are supported yet.
Using a remote control or pressing the fog button on the device the
®
FlowMarker however can always be briefly activated (heated up) again.
This sleeping mode is maintained also for
producing fog, the built-in microprocessor
go out), to ensure that the battery of a "forgotten"
destructively deep discharged!
®
The SAFEX -FlowMarker
generation in these cases is then beneficial started with a remote control.
For this the device is equipped with a remote control socket, to which an optional availa-
®
ble SAFEX - RADIO-
OPTIONAL ACCESSORIES).
By each short pressing of the pushbutton of the remote control the fog flow will be turned
on or off again. However, it may, depending on the ready state of the device possibly take
some seconds until the fog is released.
The switching status is recognizable again at the
LED. (white LED lights up = fog function is activated ).
in any position of the device.
Usually, the fog flow is only needed for some seconds, i.e.
®
model II is equipped with a shut-off feature, it enables the user to turn
only the power input socket is still connected to the
©
), they must therefore always be
cannot switch off automatically!
FlowMarker
The fog production starts than only with some
within 15 minutes,
SLEEP MODE in which the heating functions come to a standstill. Only
2 hours.
switches off completely the device
®
can excellently be used also stationary, where the fog
or CABLE REMOTE CONTROL
fog can be generated contin-
of the FlowMarker
switched off
®
model II is now equipped with an
the device automatically switches
SAFEX
Should this period pass without
(all LEDs
®
FlowMarker will not soon or later
can be connected (see chapter „G"
® ®
SAFEX -FlowMarker by the white
®
®
-