Renkforce MX100i Bedienungsanleitung Seite 44

<Clock>
Use this option to set the time , to set an alarm and to view the current alarm setting , see'' Setting the clock'', ''Setting the alarm''.
<Backlight>
Selecting this option will alter the internet radio's backlight values.
1. After select the 'Backlight' menu item, the radio will display its list of three menu modes: 'Inactive', 'Active' and 'Standby'. These
three states are explained below:
- The radio gets into its 'inactive' state when there is no user activity for 30 seconds.
- The 'active' state is when there is user activity.
- 'Standby' is the state when the radio has been turned off
2. Rotate the knob to highlight the desired menu mode and press SELECT.
3. The radio will now display the current backlight value for the menu mode. You can alter this value by rotating the knob to increase
or decrease it.
<Contrast>
Selecting this option will alter the Display 's contrast ratio values.
1. After select the 'Contrast' menu item, the radio will display the current value of LCD contrast ratio.
2. Turn the knob to increase or decrease it until the optimum display angle.
3. Press SELECT to save, then quit .
<Equalisation>
After selecting this option,there are 3 options in the menu; You can change the audio frequency response as your favourite;
1. "Treble " tone control: You can turn the knob to increase or decrease between -6 – 9 levels;
2. "Bass" tone control: You can turn the knob to increase or decrease between -6 – 9 levels;
3. "Presets" tone control: Including <Bass/Classical/Jazz/Pop/Rock/Flat> 6 styles; Press "Select" button to alter the highlight
option;
<WiFi Strength>
If you were using WiFi access to the network, you can check the current WiFi strength in this menu.
46
Operating Instructions
English
9.2.1 Comment rechercher les réseaux
1. Appuyez sur la touche BACK.
2. Tournez le bouton TUNE (8) jusqu'à ce que l'écran indique
<Confi gurer>.
3. Appuyez sur le bouton SELECT (8).
4. Tournez le bouton TUNE (8) jusqu'à ce que l'écran indique
<Confi g réseau>.
5. Appuyez sur le bouton SELECT (8).
6. Tournez le bouton TUNE (8) jusqu'à ce que l'écran indique
<Scanner réseaux>.
7. Appuyez sur la touche SELECT (8) pour rechercher le réseau.
8. Puis tournez le bouton TUNE (8) pour selectionner
l'équipement adapté.
9. Ensuite :
• L'écran indique « Connecting to network »
(Connexion réseau en cours...) lorsque la
radio tente de se connecter au réseau. :
Initialisation réseau
• Puis il affi chera :
Scanner réseaux
Réseau OK
Configurer
Config réseau
Scan
Réseau OK
59