Mounting Accessories; Power Cut-Off Function - STG-BEIKIRCH M2/200-500N/EV1/RWA Bedienungsanleitung

SHE linear drive M2/...-500N and M2/...-500N Tandem/EV1/RWA

Mounting Accessories

Hinge bracket FB9/A FB9/G for dome lights
Hinge bracket FB9/J*
*When using the hinge bracket FB9/J the eye bolt must be drilled to 8.2 mm on the drive !
Frame brackets K28/B and K29/B with 2 special clamping screws for the side clamping guides.
Can be used up to 500 mm stroke over the whole length of the drive, from 500 mm stroke in the first third of the drive.
Frame bracket K27/B with slide bracket for the bottom clamping guide. Can be used over the whole length of the drive.
The slide bracket has to be fixed at the linear drive with a starting power of 7.5 Newton meter (+/- 0.5 Nm).
Frame bracket K31 with 2 grub screws with points for the side assembling.

Power cut-off function

This function is operated using the electronic power cut-off fitted and does not require a limit switch.
Internal mechanical limit stops provide exact limits without disruptive stroke after-running. When these limit stops are
reached or block a drive in the UP-direction, the electronic power cut-off switches all drives off thanks to the increased
engine power. As the motor power is proportional to the shear and tensile forces this switch off takes place at exactly
defined forces.
Caution: Destruction of the motor. Never operate the linear drive without power cut-off.
Operate the load switch in general with 24 V protective extra low voltage
16 01/13424999495