Command Line Parameters - KWS Sockel 7 Handbuch

PPC S7
Your old BIOS is saved in a file as named, in the default drive and
directory (in this example, on the A drive).
8. Then the program prompts you
Do You Want to Update? (Y/N)
9. If you DO NOT wish to
update the BIOS, type N
and press Enter.
The program exits to the
command line. Skip the
following steps in this
section and go directly to
the next section.
Programming Flash Memory - 1FF00 OK
Please Power off or Reset System
10. Restart your system. Your BIOS should be successfully updated.

7.15.3 Command Line Parameters

You can run the BIOS flash update utility at the DOS command line. This
section describes the command line parameters and switches, with examples of
their usage.
NOTE:
This document describes parameters implemented in Award
flash update utility version 5.31. For a full list of parameters
in the version you are running, type awdflash /? and press
Enter.
9. If you DO wish to update
the
BIOS, respond Y and press
Enter. When the updating is
finished, the following
message appears:
░░░░░░░░░░░░░░░░░░░░░░░░░░░░░
Handbuch
7.BIOS
83