KWS Sockel 7 Handbuch Seite 26

PPC S7
network adapter. (The Boot Agent image is embedded in the fboot utility
itself.) This process takes approximately one minute and then fboot
exits to the DOS prompt.
Note: Care must be taken if you install the Intel(R) Boot Agent Version 4.0
and then install an older (i.e. pre-version 4.0 ) Intel(R) Boot Agent. When
reinstalling the older Boot Agent version, use FUTIL Version 3.46 or later.
Do not use the version of FUTIL or FBOOT that was provided with the older
Intel Boot Agent. If an older version of FUTIL or FBOOT is used to
reinstall, the Boot Agent configuration displayed by the PROSet and
BACONFIG utilities will be incorrect. Furthermore, attempts to
modify the Boot Agent configuration using PROSet and BACONFIG
will not work correctly either.
Updating the Boot Agent in a Windows* Environment
For instructions on updating the Boot Agent in a Windows environment,
refer to the Intel(R) Boot Agent User's Guide.
Updating the Boot Agent in the EFI Environment
For instructions on updating the Boot Agent in an Extensible Firmware
Interface (EFI) evironment, refer to the Intel(R) Boot Agent User's Guide.
Flash ROM Devices Supported
If you need to obtain a flash ROM device for your Intel(R) PRO/100+
or PRO/100B adapter, the following flash components are supported:
Vendor
AMD 28F020
ATMEL AT49BV512
ATMEL AT29LV512
ATMEL AT49LV010
ATMEL AT49LV001N
CATALYST 28F256
CATALYST 28F512
CATALYST 28F010
CATALYST 28F020
INTEL 28F010
INTEL 28F020
SGS 28F512
SST 29LE512
SST 39SF512
SST 39VF512
ST MICRO 28F512
26
Part No.
3.Funktionsbeschreibung
Handbuch