Herunterladen Inhalt Inhalt Diese Seite drucken

KWS Sockel 7 Handbuch Seite 25

Inhaltsverzeichnis

Werbung

PPC S7
4. In response to the first question from the utility, enter the
following:
a. If only one adapter is installed on your system,
enter "1" to continue.
b. If more than one adapter is installed in your system, you
will need to enter the NIC number (from the displayed list)
that corresponds to the Ethernet MAC Address of the desired
adapter.
The next information prompt should say:
Select Option (U)pdate or (R)estore:
5. Type U (update) if you want the fboot utility to update the flash
ROM device with the current version of Boot Agent software. Type R
(restore) if you want the fboot utility to write a previously-stored
flash image file onto the flash ROM device.
Note1: As part of the Update operation, fboot creates a backup file
on the floppy disk. Make sure that the write-enable tab on the
floppy disk is properly set.
Note2: Prior to the Restore operation, make sure that a flash image
file is available in the same directory as the fboot utility. This
file will have an automatically-generated filename with an .FLS
extension.
If you select the U (update) response, this prompt appears:
Create Restore Image? (Y)es or (N)o:
6. Type Y (yes) to create a flash image file from the current (not yet
updated) image of the flash ROM device. Type N (no) to cause fboot
to proceed without saving a copy of the current contents of the flash
ROM device.
If you choose not to save a copy of the current contents of the flash
ROM device (type N), fboot asks you the following question:
Continue Update Without Restore Image? (Y)es or (N)o:
7. Type Y (yes) to continue, which will update the flash image. Type
N (no) to cancel the update, which will leave the flash ROM contents
unchanged.
Note: The fboot utility automatically names the flash image file
(backup file) as XXXXXXXX.FLS, where XXXXXXXX are the last eight
digits of the adapter's Ethernet address.
Once you have answered the questions posed by the fboot utility, it
creates the flash image file (if appropriate), then writes the current
version of the Boot Agent image to the flash ROM device used by your
Handbuch
3.Funktionsbeschreibung
25

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ppc s7

Inhaltsverzeichnis