Electrolux WTSL4E201 Benutzerinformation Seite 4

4 www.electrolux.com
that would prevent the appliance door from being fully
opened.
Connect the mains plug to the mains socket only at the
•
end of the installation process. Make sure that the
mains plug is accessible after installation..
The ventilation opening in the base (if applicable) must
•
not be covered by a carpet, mat, or any floor covering.
Ensure good air ventilation in the located room to avoid
•
the back flow of gases into the room from appliances
burning gas or other fuels, including open fires.
Exhaust air must not be discharged into a flue which is
•
used for exhausting fumes from any appliances burning
gas or other fuels.
The operating water pressure at the water entry point
•
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
Do not exceed the maximum load of 9 kg (refer to the
•
"Programme chart" chapter).
The appliance must be connected to the water mains
•
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service
Centre or similarly qualified persons to avoid an
electrical hazard.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Items that have been soiled with substances such as
•
vegetable or mineral oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax
removers should be washed separately with an extra
amount of detergent before being dried in the washer
dryer.
Do not use the appliance if items have been soiled with
•
industrial chemicals.
Do not dry unwashed items in the wash dryer.
•