Fluff In The Fabrics; How To Remove The Fluff In The Garments; Hints And Tips - Electrolux WTSL4E201 Benutzerinformation

26 www.electrolux.com
2. After some seconds the display shows
the total duration of the cycles:
Final time value (washing + drying
+ anti-crease + cooling phases)
If you set a drying time of only
10 minutes, the final time
value includes also the anti-
crease and the cooling
phases.
3. Press button Start/Pause - Départ/
Pause to start the programme.
The door is locked.
The display shows the new time value
each minute.
11.4 At the end of the drying
programme
1. The appliance stops automatically.
2. The acoustic signals operate (if they
are active).
3. In the display
4. The indicator of button Start/Pause -
Départ/Pause goes off.
5. The last minutes of the drying cycle
the appliance performs the anti-crease
phase.
The anti-crease symbol
The door is still locked (the symbol
is on).
6. Press button Ein/Aus - Marche/Arrêt
for some seconds to deactivate the
appliance.
After some minutes from
the end of the
programme, the energy
saving function
automatically deactivates
the appliance.

12. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
comes on.
flashes.
7. When the door locked light
off you can open the door.
8. Remove the laundry from the
appliance. Make sure that the drum is
empty.
9. Keep the door ajar, to prevent mildew
and odours.
10. Close the water tap.

11.5 Fluff in the fabrics

During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the fabrics
during the next cycle.
To prevent the fluff in your laundry, we
recommend that you:
• Do not wash dark fabrics after you
have washed and dried light coloured
fabrics (new sponge, wool, sweatshirt )
and the contrary.
• Line dry this type of fabrics at open air
when they are washed the first time.
• Clean the drain filter.
• After the drying phase, clean the empty
drum, the gasket and the door with a
wet cloth.
11.6 How to remove the fluff in
the garments
To remove the fluff inside the drum, set a
special programme:
1. Empty the drum.
2. Clean the drum, the gasket and the
door with a wet cloth.
3. Set the rinse programme.
4. Press at the same time U./Min. - T/
min. and Extra Spülen - Rinçage + to
activate the cleaning function until the
display shows CLE.
5. Press Start/Pause - Départ/Pause to
start the programme.
12.1 The laundry load
• Divide the laundry in: white, coloured,
synthetics, delicates and wool.
• Obey the washing instructions that are
on the laundry care labels.
goes