Opening The Door; End Of Cycle - Electrolux WTSL4E201 Benutzerinformation

22 www.electrolux.com
1. Press button Start/Pause - Départ/
Pause.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pause -
Départ/Pause again.
The programme continues.
9.12 Cancelling a running
programme
1. Press button Ein/Aus - Marche/Arrêt
to cancel the programme and to
deactivate the appliance.
2. Press button Ein/Aus - Marche/Arrêt
again to activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.

9.13 Opening the door

If the temperature and level of
the water in the drum are too
high and/or the drum still
rotates you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pause - Départ/
Pause.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pause - Départ/Pause.
The programme or the delay start
continues.

9.14 End of cycle

When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the door
locked indicator
The indicator of Start/Pause - Départ/
Pause button goes off.
1. Press button Ein/Aus - Marche/Arrêt
to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew
and odours
9.15 Draining water out after end
of cycle
The washing programme is
completed, but there is water in the
drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause - Départ/Pause
button.
The appliance drains the water and spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press Ein/Aus - Marche/Arrêt some
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
goes off.
is on. The
goes