Waeco CoolFun CK40D Hybrid Bedienungsanleitung Seite 23

CK40D Hybrid
6.2 Using the coolbox
A
NOTICE! Risk of damage
 Do not switch on the device immediately after transporting it.
This could damage the cooling system. Leave the device to
stand for about 30 minutes after transporting, before you
switch it on. This allows the refrigerant to collect again in the
compressor, and the compressor does not run dry.
 Only operate the device from a single energy source. Simulta-
neous use of the thermoelectric cooling system and the com-
pressor is not permitted.
 Ensure that the objects or goods placed in the cooling device
are suitable for cooling to the selected temperature.
 Ensure that food or liquids in glass containers are not exces-
sively refrigerated. Liquids expand when they freeze and can
therefore destroy glass containers.
 Ensure that your cooler is well ventilated so that any heat cre-
ated can dissipate. Otherwise proper functioning cannot be
ensured. It is especially important not to cover the air vents.
➤ Place the coolbox on a firm base.
Connection cable plug
12 V
Connecting the cooler to 12 V (thermoelectric mode)
I
NOTE
In thermoelectric mode, the thermostat has no function and the
device cannot deep freeze.
➤ Make sure the cable between the cooler and the battery is protected by a
fuse (maximum 5 A).
➤ Plug the 12 V connection cable (see figure) into the cigarette lighter sock-
et or a 12 V socket in the vehicle.
✓ The cooler starts cooling the interior.
EN
230 V
Operation
23