Notes For Professional Electricians; Installation Instructions - Vestamatic Dz-Plus R 500 Bedienungsanleitung

83200211 H1.qxd 27.06.01
Installation and start-up:
1. Carefully pull to remove the cover cap of the Vestamatic DZ-Plus
R 500 roller shutter control.
2. Remove the screws and separate supporting frame from housing.
3. Mount the supporting frame.
There are several holes available for different switch boxes as well
as for the wall mounting. Please note the position of the combina-
tion frame Jung CD 500, alpine-white.
For wall mountings, a special surface-type housing is available.
4. Perform the wiring according to the wiring diagram.
Attention: Currently valid VDE standards must be observed
when connecting the device, in particular DIN VDE
0100/0700 as well as the currently valid regula-
tions of your local power company and accident
prevention regulations.
5. Slide the basic housing carefully into the supporting frame (make
sure not to pinch any cables) and tightly fasten the screws.
Note: Parallel control of several sunshade drive motors can only be
implemented by means of isolating relays or group control
devices.
14:22 Seite 19

Notes for professional electricians

- 19 -

Installation instructions

The delivered supporting frame must always be installed!
The following versions of cover frame Jung "CD 500", alpine-white,
are available:
Combination frame one-fold,
Combination frame two-fold,
Combination frame three-fold,
Combination frame four-fold,
Combination frame five-fold,
For surface-type installation
please use our surface-type housing, article-no. 01030820
For controlling two drives, we recommend our isolating relays:
Isolating relays TR N2S,
Isolating relays TR N2A,
G G
article-no. 01400201
article-no. 01400202
article-no. 01400203
article-no. 01400204
article-no. 01400205
article-no. 01054220
article-no. 01054120.
- 20 -