Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English-4
17. Refer to the Install Recommendation Printout to see if you will have one
18. Make the necessary data cable connections for your system. Make sure
Colored stripe on the data cable
Installing CD-Writer Plus and Software
Or, if your computer has an IDE hard drive or CD-ROM drive, follow the
data cable from the back of a drive to find the IDE controller. IDE
connectors may be labeled as PRI and SEC, IDE-0 and IDE-1, IDE-1 and
IDE-2, HD and CD-ROM, or PCI-IDE and ISA-IDE.
or two devices connected to the data cable. See page 5 for examples of
one- and two-device installations.
the cable's colored edge is aligned with both PIN-1 on the drive and PIN-
1 on the IDE controller. If the cable is attached incorrectly, your
computer may not boot up.
Colored stripe on the
data cable
PIN-1
Look for a label identifying PIN-1 next
to the IDE connector. The data cable's
colored edge is aligned with PIN-1 of
the IDE connector. This illustration
shows a specific computer. Yours may
look different. PIN-1 could be on
either side of the IDE connector.
PIN-1
The cable's colored edge i
aligned with PIN-1 on the
CD-Writer Plus drive.
Werbung
