Removing The Unit - Sony XR-CA400 Bedienungsanleitung

Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front
panel are not clean. In order to prevent this,
open the front panel by pressing (RELEASE),
then detach it and clean the connectors with a
cotton swab dipped in alcohol. Do not apply
too much force. Otherwise, the connectors may
be damaged.
Back of the front panel
Notes
• For safety, turn off the engine before cleaning
the connectors and remove the key from the
ignition switch.
• Never touch the connectors directly with your
fingers or any metal device.
22
Main unit

Removing the unit

1
Remove the front cover
1 Detach the front panel (page 6).
2 Press the clip inside the front
cover with a thin screwdriver.
3 Repeat step 2 for the other side.
2
Remove the unit
1 Use a thin screwdriver to push in the
clip on the left side of the unit,
then pull out the left side of the unit
until the catch clears the mounting.
4mm
2 Repeat step 1 for the other side.
3 Slide the unit out of its monting.