Stopping The Engine; Checking The Chain Brake; Adjusting The Carburetor - Makita EA3200S Betriebsanleitung

6-12. Stopping the engine

NOTE:

6-13. Checking the chain brake

The chain brake must be checked before every use of the
saw!
(Fig. 57)

6-14. Adjusting the carburetor

(Fig. 58)
CAUTION: Carburetor adjustment may only be done by a
specialist MAKITA service center!
SERVICE
Only adjusting screw (S) can be manipulated by the user.
If the saw chain moves in idle
, it is imperative to correct the idle speed!
Do not adjust the idle speed until after complete
assembly and testing of the saw!
Idle speed adjustment must only be undertaken when
installed guide bar and chain.
1
IMPORTANT:
6
Caution: If the chain does not stop immediately in this
chain saw in this condition! Contact a MAKITA authorized
service center.
Adjusting the idle speed
Turn adjusting screw (S) counter-clockwise
Turn adjusting screw (S) clockwise
Important: If the saw chain still moves during idle even
after you have adjusted the idle speed, do NOT use the
saw. Take it to a MAKITA service center!