Tuner; Wireless Speaker System - Pioneer XV-DV535W Bedienungsanleitung

09 Additional information

Tuner

Problem
Considerable noise in
radio broadcasts.
Auto tuning does not
pick up some stations.

Wireless speaker system

Problem
The power does not
turn on.
Audio is interrupted.
Audio is suddenly
interrupted.
Audio cannot be
received.
42
En
Remedy
• Connect the AM antenna (refer to the Setup Guide) and adjust the direction
and position for best reception. You may also connect an additional internal
or external AM antenna (refer to Connecting auxiliary components on
page 27).
• Fully extend the FM wire antenna, position for best reception, and secure to
a wall. You may also connect an outdoor FM antenna (see Connecting external
antennas on page 27).
• Turn off other equipment that may be causing the noise or move it further
away.
• If the transmitter is too close, you may want to distance it from the radio
antennas.
• The radio signal is weak. Auto tuning will only detect radio stations with a
good signal. For more sensitive tuning, connect an outdoor antenna.
Remedy
• Make sure the supplied power cord (or AC adaptor) is fully inserted into the
AC IN inlet (or DC IN inlet).
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• This system uses high frequency radio waves that have properties similar to
light, such as linearity, reflection, refraction, diffraction, and interference.
Therefore, placement of the system can result in weak radio waves and/or
interruption.
• The distance between the transmitter and wireless speaker may be too
large. Use the wireless speaker within the reach of radio wave from the
transmitter.
• The system may be close to a location generating electrical noise. If this is
the case, find a location that does not affect the sound adversely.
• There may be radio communication equipment using the same frequency
band (2.4 GHz) as this system, such as a Bluetooth device, radio LAN device,
cordless phone or microwave oven, operating nearby.
• The radio wave reception is variable depending on locations due to the
effects of obstacles and reflecting objects. Try changing the location of the
wireless speaker a little.
• The transmitter and wireless speaker are designed and sold as a pair, and
they identify each other in communication. This means that communication
is not available between separately purchased transmitter and wireless
speaker.