Macros (Sequence Of Commands) - One Forall Kameleon 4 Bedienungsanleitung

4. Make sure that your device is switched on.
5. Press the device key (TV or SAT/CBL).
6. Now, press and release the MAGIC key, then press POWER. This will set the
Sleeptimer for 15 minutes. For each keypress of the POWER key the "zZz"
animation will appear. To increase the timer by 15 minutes, simply press
POWER again (this must be done within 10 seconds). You can press POWER
up to a maximum of four times which will set the timer to 60 minutes
(4x15).
7. Once you have set the timer to the desired time, set your KAMELEON 4
down, pointing it at your device. When the programmed amount of
time has elapsed, the KAMELEON 4 will send the command for POWER,
hence turning off your device.
- While in sleeptime mode, the display will be turned off.
- The "zZz" animation (next to the POWER key) will animate every 15 seconds
indicating that the remote is in sleeptimer mode.
- To deactivate the Sleeptimer, simply press any key on the KAMELEON 4
remote. This will also turn the display back on.
- Remember, when using the KAMELEON 4 Sleeptimer, you must set the
remote so it is pointing at your device.
- The KAMELEON 4 Sleeptimer can only be set for only one device at a time.

Macros (sequence of commands)

Macros (direct)
You can program your KAMELEON 4 to issue a sequence of commands at the
press of one button. For example, you may want to turn off your TV, VCR and
Satellite at the same time. Any sequence of commands you regularly use can be
reduced to one key stroke for your convenience. A key that is programmed with
a Macro works through all modes (provided it's accessible in that mode).
Therefore a Macro should only be set on the MACRO key. However, you can
install a Macro on any key, except for the device keys (TV, VCR, SAT/CBL and
DVD), the MAGIC key and the SCREEN key.
Example: To set up a Macro that switches off your TV, VCR and SAT/CBL on the
"MACRO" key on your KAMELEON 4:
1. Press and hold MAGIC until the rabbit comes out of the hat.
2. Press 9 9 5.
3. Then press the key to which the Macro will be assigned, in this case the
"MACRO" key.
4. Next press TV, POWER, VCR, POWER, SAT/CBL, POWER.
5. To store the Macro, press and hold MAGIC until you get two blinks on
the IR Indicator and the rabbit disappears.
6. Whenever you press the "MACRO" key, the KAMELEON 4 will turn off your
TV, VCR and Satellite receiver.
18
Extra Features
WWW.ONEFORALL.COM