Device Sleeptimer - One Forall Kameleon 4 Bedienungsanleitung

Device Sleeptimer

If your television or satellite receiver has a "Sleeptimer" function built in, you
can access this function with your KAMELEON 4 remote. To do so:
1. Make sure your TV (or satellite receiver) is switched on.
2. Press the device key TV (or SAT/CBL).
3. Point the KAMELEON 4 at your television (or satellite receiver) and press
and release the MAGIC key then press POWER. You should see the
Sleeptimer activate on your TV screen.
To increase the timer, simply press POWER again (within 10 seconds) until
the timer gets to the desired time.
- To deactivate the "Device Sleeptimer", repeat steps 1 – 3 above. During step
3, continue pressing POWER again (within 10 seconds) until the timer
indicates zero minutes.
- Depending on how you used sleeptimer on the original remote, you might
need to access sleeptimer in a different way (through menu for example).
The KAMELEON 4 Sleeptimer
If your device does not have a sleeptimer function built in, you can install the
"KAMELEON 4 Sleeptimer" function.
1. Press the device key (TV or SAT/CBL).
2. Then, press and hold the MAGIC key until the rabbit comes out of the
hat.
3. Press 9 7 0. The bottom part of the animated IR Indicator will light up twice
again.
- It is only necessary to follow steps 1, 2 and 3 once. For subsequent use of
the "KAMELEON 4 Sleeptimer", simply follow steps 4, 5, 6 and 7.
- To switch the KAMELEON 4 back to "Device Sleeptimer", repeat steps 1, 2
and 3. The IR Indicator will blink 4 times.
It is possible to set the KAMELEON 4 Sleeptimer for 15, 30, 45 or 60 minutes.
To do this; see next page...!
WWW.ONEFORALL.COM
Extra Features
Sleeptimer
17