Learning Feature - One Forall Kameleon 4 Bedienungsanleitung

(How to copy functions from your original working remote onto the
The KAMELEON 4 comes with a complete library of pre-programmed codes.
After you have set up the KAMELEON 4 for your device, you may find that there
are one or more keys that you had on the original remote control, which do not
have a place on the KAMELEON 4 keypad.
The KAMELEON 4 offers a special Learning feature that allows you to copy
almost any function from your original remote control onto the keypad of the
KAMELEON 4.
Before you start:
- Make sure your original remote is working correctly.
- Make sure neither your KAMELEON 4, nor your original remote
control is pointing at your device.
Learning (direct)
Example: To copy the "mono/stereo" function from your original TV
remote control onto the "16:9"-key of your KAMELEON 4.
1. Place the KAMELEON 4 and your original remote control on a flat sur-
face. Make sure the ends which you normally point at your device are
facing each other. Point the original remote to the front left side of
the KAMELEON 4 (see picture below). Keep the remotes at a
distance of 2 to 5 cm (0.8 to 2 inches).
2
3.
4.
5.
6.
7. If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning. If your
want to copy another function in a different mode, simply continue with step
4 followed by steps 5 and 6.
8.
WWW.ONEFORALL.COM

Learning Feature

Press and hold down the MAGIC key (for about
3 seconds) until the rabbit comes out of the hat.
Press 9 7 5. The bottom part of the animated
IR Indicator will blink twice.
Press the device key (Example: TV key) on the KAMELEON 4
remote to select the mode to which you want to copy the
learned function.
Press the key (Example: "16:9" key) on the KAMELEON 4
remote where you want to place the learned function. The IR
Indicator will show "incoming IR" three times and then the
display will switch off.
Press and hold the key that you want to copy (Example:
mono/stereo) on your original remote control. The display
switches back on and you will see two blinks to indicate
successful learning operation.
To exit the learning mode, press and hold down
the MAGIC key (for about 3 seconds) until the
bottom part of IR Indicator blinks four times.
KAMELEON 4)
11