Sharp PG-A10S-SL Anleitung Seite 25

No. Adjusting point
8 RGB
countervoltage
adjustment
9 RGB white
balance adjust-
ment
10 sRGB adjust-
ment
11 Automatic color
irregularity
correction
12 Video Tint
adjustment
13 Video Color
saturation
adjustment
14 DTV Tint adjust-
ment
Adjusting conditions
1. Feed the countervoltage
adjustment signal. (SVGA)
2. Select the following group
and subjects.
Group : OUTPUT3
Subject : RC (R)
GC (G)
BC (B)
1. Feed the RGB 50% gray
signal. (SVGA)
2. Select the following group
and subjects.
Group : OUTPUT1
Subject : R1-BLK(R)
B1-BLK(B)
1. Feed the RGB 50% gray
signal. (SVGA)
2. Select the following group
and subjects.
Group : OUTPUT1
Subject : S-R1-BLK
S-R1-GAIN
S-G1-BLK
S-G1-GAIN
S-B1-BLK
S-B1-GAIN
1. Apply the automatic color
correction using the auto-
matic color irregularity cor-
rection system.
1. Select the following group
and subject.
Group : VIDEO
Subject : N-Tint
P-Tint
S-Tint
1. Select the following group
and subject.
Group : VIDEO
Subject : N-Color
P-Color
S-Color
1. Select the following group
and subject.
Group : DTV
Subject : Tint
Adjusting procedure
1.Using the set's control switch or the remote control-
ler's button, adjust the setting so that the flickering
be minimum.
2.Adjust the setting so that the image comes to the
center of the screen.
1.Adjust the R1-BLK and B1-BLK settings to have the
chromacity of x = 290 ± 5 and y = 323 ± 5. (8500K)
1.Adjust the S-R1-BLK and S-B1-BLK settings to have
the chromacity of x = 313 ± 5 and y = 344 ± 5.
(6500K)
1.Make sure that no remarkable uneven color remains
on the screen.
1. Check the fixed value.
N-Tint : 8
P-Tint : 8
S-Tint : 8
1. Check the fixed value.
N-Color : 10
P-Color : 10
S-Color : 10
1. Check the fixed value.
Tint : 8
25
PG-A10S
PG-A10S-SL
AN-A10T