Werbung
Verfügbare Sprachen
Verfügbare Sprachen
trigger the bell.
1: Whistle
2: Bell
3: Smoke generator on/off
4: Sound on/off
5: Announcement, spoken in the
"Plattdeutsch" dialect: "Leewe
Lüt, stiegt man in. Set you doal
un moak de Döarn to. De Toch
fahrt nu aff." (Dear people, get
on the train. Sit down and close
the doors. The train is going to
leave now.)
6: Brake sound
7: Coal shoveling
8: Air pump, slow
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board will be set to OFF. The DIP
switches should remain in this
setting, even if the models are
used on an analog layout.
Lighting
This model features directional
lighting. The model has a "flat"
multi-purpose socket, with a
removable cover, on the rear of
the cab. This socket can be used
to provide track power to cars with
lighting or sound electronics.
To remove the cover of the
socket, pull it straight out. If the
cover is tight, gently use a small
straight screwdriver to pry it out.
(Do not pull out the rectangular
outer housing.)
Sound
This model features a digital elec-
tronic sound system. The volume
control is located under the remo-
vable rear steam dome (Fig. 6).
Bell and whistle: The whistle
sounds automatically when the
locomotive is started.
The bell and whistle can also be
triggered by the LGB Sound
Magnet (17050) included with this
model. The 17050 snaps between
the ties of most LGB track sec-
tions.
The magnet in the 17050 is under
the LGB logo. If the contact is
installed with the logo on one side
of the track, it will trigger the
whistle as the model passes. If
the contact is reversed, it will trig-
ger the bell.
Air pump: After the model stops,
the air pump sounds several
times, then you hear the injector
and the safety valve. If a low vol-
tage (approx. 6.5 volts) is maintai-
ned, the standing sounds will con-
tinue to sound at regular intervals
while the loco is stopped.
Hint: If this model is not used for
a long time, its capacitors will
discharge, and the sound system
will operate erratically. To rechar-
ge the capacitors, operate the
model at brisk speed for about 30
seconds. This model does not
require a battery.
Hint: This model is equipped with
a starting delay circuit. This ena-
bles the model to produce stan-
ding sounds while it is stopped.
Attention! Do not connect this
model to other loco models with
different starting characteristics.
This can damage the internal
gearing.
Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gene-
rator is overfilled, it will not con-
vert the fluid into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010).
Other fluids may damage your
locomotive.
Attention! Never touch the hea-
ting element in the center of the
smoke generator. It is fragile.
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of at
least 1 amp. For more informati-
on on LGB power supplies for
indoor, outdoor and multi-train
operation, see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
9
Werbung
