Presettings - ergoline Turbo Power Gebrauchsanweisung

Presettings

Operating states can be called up and the presettings can be entered in
the presetting mode.
Changing to Presetting mode
S E R V I C E
Start screen after the service key (1) has been inserted and the START
button (2) has been pressed.
72
Changing a presetting
In presetting mode you must always press the button that the command
displayed on the screen is assigned to.
The button's function depends on the command displayed on the screen
above the button and the menu level that you are in.
Example on the left: Press the STOP button (3) on the start screen to run
the ENT (enter) command.
>:
<:
RES: Press RES (RESET) to reset the running hours counter. The as-
signed button must be kept pressed down for 3 seconds to do this.
MEMO: Press the MEMO button to save the changed value. The follo-
wing is always displayed if the data was saved successfully:
M E N U
E N T
Enter the change once again if PARAMETER NOT PROGRAMMED is
displayed.
Display the next menu or increase a pre-set value.
Display the previous menu or decrease a pre-set value.
P A R A M E T E R
P R O G R A M M E D
Note:
The device automatically reverts to standby mode 180 seconds
after the last key was pressed. The current preset value will be
imported.