Palmer FAT50 Handbuch Seite 6

IMPoRTANT SaFeTY INSTRuCTIoNS:
CauTioNS
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
euroPeaN MoDeLS
A power cord is supplied with an IEC molded socket at one end and a molded mains plug at the other end.If the
fitted plug is unsuitable for your type of outlet sockets, it should be cut off and disposed of safely, in case it is
inserted into a live socket elsewhere. If any part of the power cord set is damaged, the complete cord set should
be replaced. The following information is for reference only.
The wires in the mains lead are coloured in accordance with the following code:
Earth (Ground): Green and Yellow (US - Green/Yellow)
Neutral: Blue (US - White)
Live (Hot): Brown (US – Black)
As the colours of the wires in the mains lead may not correspond with the colored markings identifying the termi-
nals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with
the letter E, the earth symbol, or colored Green or Green and Yellow.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter N or
colored Black.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the letter L
or colored Red
Ensure that these colour codes are followed carefully in the event of the plug being changed. Ensure that all termi-
nals are tightened securely and no loose strands of wire are present. Ensure that the cord grip is clamped over the
outer jacket of the cable rather than over the wires.
eMC (FCC reGuLaTioN warNiNG, u.S.a. oNLY)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a parti-
cular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Re-orient or coil cables.
• Consult the dealer or an experienced radio/television technician for additional suggestions.
Unauthorized changes or modification to this system can void the user's authority to operate this equipment.
6