Herunterladen Inhalt Inhalt Diese Seite drucken

Palmer FAT50 Handbuch Seite 15

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4 oPeraTiNG THE FAT50:
CHaNNeL SeLeCTioN
Use the front panel CLEAN/ DRIVE switch or the Palmer 4-on-the-floor switch for channel selection. Red LEDs on
the front panel and the footswitch light up when the DRIVE channel is active.
THe GaiN FuNCTioN
Use the front panel LOW GAIN/ HIGH GAIN switch or the Palmer 4-on-the-floor switch to select the gain mode. The
yellow LED on the front panel and a yellow LED on the footswitch light up when HIGH GAIN is active.
CLEAN channel + HIGH GAIN = CRUNCH mode
DRIVE channel + HIGH GAIN = HEAVY LEAD mode
THe briGHT/ NorMaL FuNCTioN
Adding brilliance, the BRIGHT setting is indicated by the green LED on the front panel.
reverb
Use the front panel reverb control to set the amount of reverb mixed in with your guitar signal. The integrated
spring reverb is always on unless the 4-on-the-floor switch is connected to turn it off and on. The (red) LED on the
footswitch lights up when the reverb is active.
MaSTer aND 2ND LeveL
Use the 4-on-the-floor switch to select MASTER volume or 2nd LEVEL (alternate master, rear panel). The red LED
on the footswitch lights up when MASTER is active.
THe FaT50 wiTH eFFeCTS
The FAT50's FX loop provides parallel or series operation and FX level setting. The rear panel control both switches
from parallel (DRY, hard left) to series (WET, fully clockwise) and mixes the FX signal in with the direct signal in
parallel mode (0 – 9). In series operation the power amp receives the FX signal only.
Caution: The FX control must be set to DRY when no effects are connected.
CoNNeCTiNG FX:
• Connect FX Send to the input of the effect, and the effect output to FX Return.
• Adjust the output level of the effect: turn the FX control fully clockwise (WET), set level short of clipping the FX
Return.
• Use the rear panel FX control to set the amount of effect mixed in with the direct signal.
The RETURN socket can also be used to connect another instrument, drum machine, MP3 player, etc. Use the FX
control to balance the guitar and additional signal levels.
15

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Fat50h

Inhaltsverzeichnis