Palmer FAT50 Handbuch Seite 13

2 CoNNECToRS & CoNTroLS:
25 FX-reTurN
This receives the signal from your effect(s). Connect the output of your effect(s) to this socket.
26 DrY/weT
This selects parallel or series operation of the FX loop and controls the effect level.
Power aMPLiFier ouTPuTS
For correct impedance matching the FAT50 provides 8 and 16 Ohm loudspeaker outputs. The minimum load is 8
Ohms (1 x 8 or 2 x 16 Ohms). The internal loudspeaker of the combo version is connected to the 16 Ohm output
(labeled INTERNAL SPEAKER).
Caution: Do not operate the amp without appropriate loads (8 Ohms minimum) to prevent power amp damage.
Make sure the loudspeaker impedance matches the output impedance of the amp. Do not use loudspeakers rated
below the output power of the amp!
27/ 28 8 oHMS ParaLLeL
The 8 Ohm loudspeaker outputs are paralleled. Use these to connect a single 8 Ohm cabinet, or two 16 Ohm
cabinets.
29/ 30 16 oHMS SerieS
The 16 Ohm loudspeaker outputs are wired in series. Use these to connect a single 16 Ohm cabinet (to the socket
labeled INTERNAL SPEAKER) or two 8 Ohm cabinets. The 16 Ohm loudspeaker of the FAT50 Combo must be
connected to the INTERNAL SPEAKER output (29).
Use the INTERNAL SPEAKER output (29) exclusively if you are connecting a single 16 Ohm cabinet. For two 8 Ohm
cabinets use the INTERNAL SPEAKER (29) and unlabeled 16 Ohm (30) outputs. An 8 Ohm cabinet must be connec-
ted to (29) to use output (30).
13