Entering Personal Data; Positioning The Scale; Operation - Ideen Welt TGF-302H Bedienungsanleitung

ENTERING PERSONAL DATA

There are 12 memory locations available (P0 – P9, PA, Pb) for saving gender, height, age as well as
performance level (athlete mode). Carefully step on the left or right front corner to turn the scale on. The LCD
display (4) shows
location.
Follow the illustration to set gender, age, height and performance level.
Using the buttons
•
Memory locations available are P0 - P9, PA, Pb.
•
Age must be between 10 - 99 years.
•
Height must be within 60 - 240 cm.
•
Enter your performance level, choosing from A0-A4 according to the following legend:
A0 low mobility lifestyle
A1 normal, active daily movement
A2 little athletic activity
A3 a lot of athletic activity
A4 professional athlete

POSITIONING THE SCALE

1. Always place the scale on a level, hard and non-skid surface, not on carpets or unstable floors.
2. Make sure that the scale is situated out of the reach of children, so that they cannot use it as a toy and
damage it.
3. Place the scale on a dry place, protected from moisture and heat.
Important: Remain very still while standing on the scale. In order to achieve
consistent weight measurements, be sure to keep your weight evenly balanced. Do
not shift weight while standing on scale.

OPERATION

NORMAL WEIGHING
1. Step with one foot on the left or right front corner to
switch the scale on. The LCD display shows
and switches to 0.0 after a short period. If no data
have been entered, the scale switches off
automatically.
2. Weigh yourself preferably without clothes and
shoes, always at the same time of the day and
before eating. Keep a notebook with your weight values to be able to notice any fluctuations.
3. Step on the middle of the glass plate (7) and stand still. The scale begins to calculate weight. After the
weight has been calculated, the result blinks twice on the LCD display and will be then shown
continuously. The result will not be stored.
4. When you step off the scale, the LCD display switches back to 0.0 and switches off automatically after
approx. 15 seconds.
5. If the scale is overloaded, there will be „Err" on the LCD display and the scale switches off
automatically.
6. With the unit switch (9) on the bottom side of the device you can select the unit of the weight display.
Set the switch to the desired setting (kg = Kilogram; Lb = Pound; St = Stone und Pound/Stone).
briefly and then switches to 0.0. Press the SET button (2) and choose a memory
(1, 3), the values can be adjusted and confirmed with the SET (2) button.
12
t