Inhaltsverzeichnis
Werbung
English
UK
FFZ-400N SCROLL SAW MACHINE
The following warning symbols are used in this operating
manual:
Danger of fatal injury and possible damage to
the machine if the instructions in this manual are
not observed.
An electric current is present.
Carefully read this operating manual before commissio-
ning the machine. Acquaint yourself with its function and
operation. Maintain the machine in accordance with the
instructions so that it will always work faultlessly. This ma-
nual and the accompanying documentation must be sto-
red near the machine.
SPECIAL SAFETY REGULATIONS
When using an electric machine, always observe the
local safety regulations with regard to the risk of fire,
electric shock and injury. In addition to the following
instructions, read the safety regulations in the rele-
vant special section.
•
Always wear safety glasses and a dust mask.
•
Use this scroll saw machine only indoors.
•
Ensure that the teeth of the saw point downwards be-
fore using the machine.
•
If any of the saw blade's teeth are missing or damaged,
immediately replace the blade.
•
Instal the scroll saw machine on a level, stable surface.
•
To avoid breaking the saw blade, never exert lateral
pressure on it.
•
Before cutting, check wooden work pieces for protru-
ding nails etc.; remove any found.
•
Do not touch the surface area to be sawed.
•
Do not allow the saw machine to run unattended.
•
When the machine is operational, wood remnants etc.
near the saw blade must not be removed by hand. De-
activate the machine before removing remnants.
2
TECHNICAL DATA
Voltage
230 V~
Frequency
50 Hz
Power consumption
90 W
Speed count w/o load/min
1440
Max saw depth 90°
50 mm
Max saw depth 45°
15 mm
Weight
15 kg
L pa (sound pressure) w/load
62.6 dB(A)
L pa (sound pressure) w/o load
66.4 dB(A)
Electrical safety
Check that the mains voltage corresponds to the voltage
listed on the rating plate.
Mains connection
Only use earthed sockets with earthing wire connected
per the regulations.
Replacing the mains connection cable
The mains connection cable may only be replaced by a
special cable in a specialised workshop.
Replacing cables or plugs
Dispose of old cables or plugs immediately after replacing
them. It is dangerous to connect the plug of a loose cable to
a wall socket.
Using extension cables
Only use an approved extension cable, corresponding to
the machine power use. The wires must have a minimum
cross section of 1.5 mm
2
. If the cable is on a reel, it must be
fully paid out.
CONTENT OF THE PACKING
1 scroll saw
1 protective cover
1 screw for installing the protective cover
2 saw blades
2 adapters for universal saw blades
2 Allen key
1 dust blow pipe
3 rubber feet
3 screws with nuts and rings for installing the rubber feet
1 cross guide
1 operating manual
1 safety manual
1 warranty card
Check the machine, loose parts and acces-
sories for transport damage.
EXPLODED VIEW
Ferm
Ferm
43
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
