Sharp EL-2607PC Bedienungsanleitung Seite 6

Multiplication:
The calculator will automatically remember the first
number entered (the multiplicand) and
instruction.
Division:
The calculator will automatically remember the
second number entered (the divisor) and
instruction.
''•'': Neutral
''A'': Use of the Add mode permits addition and
subtraction of numbers without an entry of
the decimal point. When the Add mode is
activated, the decimal point is automatically
positioned according to the decimal selector
setting.
Use of , and
the Add mode and decimally correct answers will
be printed at the preset decimal position.
ROUNDING SELECTOR:
" ": An answer is rounded up.
"5/4": An answer is rounded off.
" ": An answer is rounded down.
Note: The decimal point floats during successive
calculation by the use of
will automatically override
or .
If the decimal selector is set to "F" then the answer
is always rounded down ( ).
GRAND TOTAL / RATE SETTING MODE
SELECTOR:
"GT": Grand Total
"•": Neutral
" ": Set this selector to the "RATE SET" posi-
tion before storing each rate.
• Enter the adding conversion rate, then
press
• A maximum of 6 digits can be stored
(decimal point is not counted as a digit).
Note: • Be sure to set this selector to the
"•" position after storing an each
rate.
• Only one rate can be stored. If
you enter a new rate, the previous
rate will be cleared.
PAPER FEED KEY
LAST DIGIT CORRECTION KEY
GRAND TOTAL KEY
CLEAR ENTRY KEY
TOTAL KEY
4
.