Wiring Connection - Kenwood KDC-210UI Bedienungsanleitung

INSTALLATION/CONNECTION

Wiring connection

When connecting to an external
amplifier, connect its ground
wire to the car's chassis to avoid
damaging the unit.
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ]
: Rear speaker (right)
B2 Purple/black [
B3 Gray ]
: Front speaker (right)
B4 Gray/black [
B5 White ]
: Front speaker (left)
B6 White/black [
B7 Green ]
: Rear speaker (left)
B8 Green/black [
Antenna
terminal
Output
terminals *
Ignition wire (Red)
Unit
Battery wire (Yellow)
Yellow (Battery wire)
Red (Ignition wire)
Yellow (A4)
ISO
connectors
Fuse (10 A)
*
: Not available
If no connections are made, do not let the wire come
out from the tab.
Light blue/yellow
STEERING WHEEL
(Steering remote REMOTE CONT
control wire)
Blue/White
ANT CONT
(Power control wire/
Antenna control wire)
Red (A7)
Brown
(Mute control wire)
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially available
custom wiring harness specific for your car and leave this job to
professionals for your safety. Consult your car audio dealer.
REMOTE INPUT
To the steering wheel
remote control adapter
To the power control
P. CONT
terminal when using the
optional power amplifier
or to the antenna control
terminal in the vehicle
To the terminal that
MUTE
is grounded when the
telephone rings or during
conversation ( 13)
(To connect the Kenwood
navigation system, refer
your navigations manual.)
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
17
ENGLISH