Preparations; General Remarks; Charging And Installation Of The Airplane Batteries - Carson SA315B Lama Betriebsanleitung

8
GB
7. After completing the steps above, you can
shut the cover of the transmitter again and
fasten all the screws.
10
CH2
8. When the back cover is closed, please turn on the transmitter for
the reset of the trimming.
CH2: Adjust the CH2 trimming up or down and make sure it is in the
neutral position.
CH3: Adjust the CH3 trimming down and make sure it is in the lowest
position.
g. Preparations

General remarks

• If you have no or little experience with airplane models, you should
first practice with a flight simulation program.
• Seek advice from an experienced R/C user for the first few
attempts.
• Acquaint yourself with the control functions of the transmitter.
• Begin your flight experiments standing behind the model, the line
of sight in the flight direction. In this case, the control reaction is
the same as the direction of control.
Furthermore acquaint yourself with the control of the model as it
comes towards you (side-inverted reaction to the direction of control)!
38 CARSON Air Zermatt SA 315B „Lama" 50 050 7041
9
CH2 Trim CH3 Trim
CH3
9. At last, turn on the power of the receiver, have a nice flight.
Charging and installation of the airplane
batteries
Always charge the battery outside of the model!
• Connect the battery charger with the battery adapter.
• Plug the plug battery charger in a power socket.
• Connect the battery with the Lipo Balance charger.
• Make sure that the connector is inserted correctly to avoid a short
circuit.
• Do not cover the battery!