Description Of 2.4 Ghz Remote Control System; Product Information - Carson SA315B Lama Betriebsanleitung

e. Description of 2.4 GHz Remote Control System

1. Product information

The Carson 2.4 GHz system finds a free transmitting frequency
automatically, so does not need to be equipped with the transmitter
and receiver crystal that are
normally required.
Bind button
Transmitter
2. Connection
diagramm
Transmitter
3. Calibrating the 2.4 GHz system
To synchronise the transmitter with other receivers, please following
the following procedure:
1. Put batteries/accumulators into the 2.4 GHz transmitter and switch
it off.
2. Press the bind button that is linked to the receiver via a cable.
3. Connect the battery lead to the receiver (Illustration 1).
The 2 LEDs begin to flash and confirm the "match" status for
synchronising the transmitter and receiver.
4. Press and hold down the synchronisation button on the
transmitter, then switch the ON/OFF switch on the transmitter to
ON (Illustration 2).
5. Release the bind button on the transmitter and receiver again.
NOTE!!!
The built-in components are already coordinated. These must not be
re-synchronised.
CH 1
CH 2
6. Check the LEDs on the receiver. If the LEDs are no longer flashing,
the synchronisation process has been successfully completed.
However please wait for a further 10 seconds.
7. Connect the servo plug to the receiver and check that it works
(Illustration 3).
8. If the test is not successful, please repeat the procedure starting at
point 1.
9. If the test is successful the accumulator pack may be reconnected
to the accumulator plug.
The synchronisation of the transmitter and receiver is now complete.
CARSON Air Zermatt SA 315B „Lama" 50 050 7041
Bind button
Receiver unit
Battery
Receiver unit
GB
35