Steps For Connecting Your Radio To Your Wireless Network; Step 1 - Power Up The Radio; Step 2 - Scan For A Wireless Network Connection - Block IR 100 Bedienungsanleitung

Instruction Manual Wi-Fi Internet / FM Radio Model: IR 100
_____________________________________________________________________________________________________________
Steps for connecting your radio to your wireless
network

Step 1 - Power up the radio

Connecting a power supply with a correct rating, turn power switch on, wait for about 15 seconds, Display
light up.
Note: if you would like to give your radio a static IP address then please see the 'Network config' section
under the 'Settings' section at the end of the guide.
The display on the front of the radio will light up and say:
Initialising
After a few seconds, this will change to show:

Step 2 - Scan for a wireless network connection

When the display says <Scan for networks>, press the SELECT button.
(Note: if you make a mistake at any point, press the BACK button to go back to the previous screen.)
The radio will now scan for all available wireless networks and will display:
If it can't find one then the display will say:
Networks Found
If this happens then you will have to get your wireless access point working - see the instructions supplied
with it.
When the radio finds your wireless network, it displays the ESSID for the access point on the screen - this
is a name that is allocated to the access point by the person who set up the network - for example:
< My Home Network
It is possible, and in some locations highly likely, that your radio will find more than one wireless access
point, in which case you can choose which one you want to connect to. Turn the knob on the radio to see
the ESSID for each access point the radio has found.
network
Scanning
Scanning
No Wireless
>
27