Error Messages And Troubleshooting (General); Error Description; Error Messages And Troubleshooting (Network); Care And Transport - Block CR-10ToGo! Bedienungsanleitung

Error Messages and Troubleshooting (General)

Error Description

Possible cause and remedy
No power, though the - The power cable is not connected
device is turned on - The socket is defective
- The fuse in the device is defective – must be repaired by a technician
- The power cord is defective – must be repaired by a technician
No sound - The device is not on
- The volume is too low
- The loudspeaker cable is not connected correctly
- No input signal
- The device has the wrong input
No sound on a channel - The audio input is connected incorrectly
- The selection of the input is wrong
- The speaker cable is connected incorrectly
- The speakers are defective
Loud hum - An audio cable is not connected properly or is defective
- The turntable is not grounded
- Your device is too close to another device or the TV
Weak bass - The phase at the speaker is not connected correctly change +/-
Distorted sound - Volume, bass or treble are set too high
- Loudspeakers could be defective
- There is a jumper on the speaker cable (short circuit)
The remote control does not - Check if the batteries are correctly inserted
work - Are the batteries empty? Please replace them with new ones
- Point the remote control towards the receiver on the device
- Remove any objects between the remote control and the unit
- Determine if the distance between the remote control and the device is more than 8 meters
Keys do not work - Turn the unit off and then on again.
(Device or remote control) - Alternatively, disconnect the device from the power supply and then reconnect it.
(External current inlets can affect the device)
Disturbance in the reception - The transmitter is not set correctly
- The antenna is not aligned correctly
- Start a station search again
Network connection is not - The network is currently unavailable. Try again later
possible - The router does not allow connection, since the device still hasn't received an
address. Start the setup wizard
- Check the distance between the router and the device
- Change the selected encryption method on the router
- Determine if a firewall rejects the device
58

Error messages and troubleshooting (network)

Report reason
No Connect 1. Incorrect Password
2. Correct password, no contact to the router
Format Error The file format is not recognized
Network Error Incorrect information is received from the
network
Network not Problems with the connection to the router
available
Network No answer regardless of the network
timeout
No UPnP No UPnP server was found
found
Not authorised Incorrect password entry or not logged in
on UPnP Server
Update failed Software Update failed
!
Only authorized qualified personnel may carry out repairs and
interventions in the device.

Care and transport

Care and cleaning of the appliance
Before you clean it, disconnect it from the power supply. Use only clean and dry cloths to clean your appliance.
If the appliance is very dirty, you can clean the unit with a damp cloth and mild cleaning fluid. Never use liquids
such as gasoline, alcohol, petroleum or other solvents.
Transport The unit
Please keep the packaging and the instructions for use so that you can pack the unit properly for transporting
or shipping. The original packaging is designed so that you can safely transport or ship the device. Please keep
this manual for future reference.
Remendyng
1. Enter the correct password
2. Disable Mac filter on the router
Make sure the stream is encoded in WMA, MP3,
or FLAC at not more than 48 KHz. If not, please
recode.
The data from the server are not readable.
Possibly reboot the CR-10ToGo! and router.
Turn on or restart the router
The selected station can not be received at
the time, please change the transmitter
Make sure your media server is on the same
network as your CR-10ToGo! and it is turned on.
Enter the correct password.
Check your network settings or try it again
later
59