Important Notices - Radiodetection rd7000+ Bedienungsanleitung

CALSafe
CALSafe enabled RD7000+ (PLM and TLM models only) are equipped with a system
which does not permit them to function once they are beyond the expected service/
calibration date.
When the unit is within 30 days of the service due date the unit will display at startup the
number of days left. The locator will stop functioning on the service due date.
You can edit the CALSafe service due date or disable this function using the RD Manager
PC software. Refer to its operation manual for further information.
Automatic Logging
RD7000+ logging models (PLM and TLM) offer a powerful data logging system which
records all the instrument's critical parameters and warnings in its internal memory at the
rate of 1/sec.
The automatic logging system is always active and cannot be disabled. Its memory is
capable of storing at least 1 year's worth of normal usage data – based on 4 hours
operation per day, 5 days per week, 20 days per month.
Logs can be retrieved using the RD Manager PC application for usage analysis and
survey validation. Refer to its operation manual for further information.

Important notices

When reporting any problems to your Radiodetection Dealer or Supplier it is important to
quote the unit serial number and the purchase date.
This instrument, or family of instruments, will not be permanently damaged by reasonable
electrostatic discharge and has been tested in accordance with IEC 801-2. However,
in extreme cases temporary malfunction may occur. If this happens, switch off, wait and
switch on again. If the instrument still malfunctions, disconnect the batteries for five
seconds and then reinstall and switch the unit on.
Compliance
EU Compliance
This equipment complies with the following EU Directives:
• R&TTE Directive: 1999/5/EC
• Low Voltage Directive: 2006/95/EC
• EMC Directive: 2004/108/EC
20