Radiodetection rd7000+ Bedienungsanleitung Seite 17

technology is considered hazardous. This may include: petrochemical facilities,
medical facilities or around navigation equipment.
Switching Bluetooth on
By default RD7000+ locators and Bluetooth enabled transmitters are shipped with the
Bluetooth wireless connection module disabled.
1. Press the key to enter the menu.
2. Scroll to the BT menu using the
3. Press the
key (locator) or the
4. Scroll up or down to the ON option.
5. Press the key to switch Bluetooth ON and return to the previous menu.
Switching Bluetooth off
You can switch Bluetooth off to prolong battery life or comply with regulations in areas
where wireless communications are considered hazardous.
1. Press the key to enter the menu.
2. Scroll to the BT menu using the
3. Press the key (locator) or the
4. Scroll up or down to the OFF option.
5. Press the key to switch Bluetooth off and return to the previous menu.
Pairing to a PDA or PC
Connection requirements:
• Any RD7000+ locator.
• A compatible Bluetooth enabled PDA or Bluetooth enabled PC or Laptop.
NOTE: The procedure below describes the pairing process between a RD7000+
locator and a PDA. Pairing to a PC follows the same steps for the RD7000+ locator
and similar steps for your PC or laptop. Consult your PC or laptop Bluetooth pairing
instructions to pair with the RD7000+ locator.
Pair the RD7000+ locator to your PDA using your PDA's Bluetooth software.
NOTE: The procedure for pairing your PDA may differ depending on the PDA make
and model. The following procedure should apply to most PDAs.
On the locator:
1. Press the key to enter the menu.
2. Scroll to the BT menu using the
3. Press the key to enter the BT menu.
4. Scroll up or down to the PAIR menu.
or keys.
key (transmitter) to enter the BT menu.
or keys.
key (transmitter) to enter the BT menu.
or keys.
17