Radiodetection rd7000+ Bedienungsanleitung Seite 19

Bluetooth error codes
If an error occurs when attempting to perform any Bluetooth command using the locator
to the transmitter or the locator to a PC or PDA, the LCD will display a code to help you
resolve the problem on the locator.
The codes are as follows:
B T CO D E D E S CR I P T I ON
BT001 Bluetooth not configured for this unit
BT002 Internal Bluetooth error
BT004 Locator not paired with PC/PDA
BT005 Paired but connection attempt failed. Power cycling may be required
Survey Measurements
The RD7000+ locator models can transmit survey measurements to a paired Pocket PC
(or PDA) with GPS, running a compatible application such as SurveyCERT.
Saving measurements
To save survey measurements, press the
To achieve accurate results the locator must be kept as still as possible during the saving
process.
If your PC or PDA is out of reach the locator will display an error code. To avoid these
errors disable the Bluetooth survey measurements transmission or ensure that your PC or
PDA is within range and correctly paired.
NOTE: A flashing depth and/or current reading display means that the
measurement is poor and should be taken again. Poor readings may be caused by
nearby conductors or sources of electromagnetic interference.
To obtain SurveyCERT for PDA:
SurveyCERT for PDAs and its operation manual are available as a free download from the
Radiodetection website:
Visit www.radiodetection.com.
1.
2. Using the menu bar, go to Support -> SurveyCERT.
3. Click on the RD7000+ SurveyCERT link to get to the SurveyCERT download page
and follow the instructions.
key.
19