Functional Description; Intended Use; Product Features - Bosch PST 900 PEL Originalbetriebsanleitung

OBJ_BUCH-1053-001.book Page 20 Tuesday, September 29, 2009 8:16 AM
20 | English
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fit-
ted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the orig-
inal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should nev-
er be inserted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a re-
sidual current device (RCD) with a rated re-
sidual current of 30 mA or less.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
2 609 003 953 | (29.9.09)

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-off button for On/Off switch
2 Thumbwheel for stroke rate preselection
3 On/Off switch
4 Vacuum hose*
5 Vacuum connection
6 Base plate clamping lever (PST 1000 PEL)
7 Base plate
8 Adjusting lever for orbital action
9 Switch for sawdust blowing device
10 Dust cover for vacuuming
11 Sliding shoe (PST 1000 PEL)
12 "Cut Control" viewing window
13 "Cut Control" base
14 Worklight
15 Handle (insulated gripping surface)
16 Stroke rod
17 SDS clamping lever for saw blade release
18 Guide roller
19 Saw blade*
20 Contact protector
21 Saw blade storage (PST 900 PEL)
22 Splinter guard*
23 Lead for the parallel guide
24 Screw (PST 900 PEL)
25 Scale for mitre angle
26 Parallel guide with circle cutter*
27 Locking screw for parallel guide*
28 Centring tip of the parallel guide*
29 Cutting mark, 0°
30 Cutting mark, 45°
31 Cutting mark, 45° (with sliding shoe)
(PST 1000 PEL)
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools