Starting Operation; Working Advice - Bosch XEO Originalbetriebsanleitung

OBJ_BUCH-377-007.book Page 21 Tuesday, August 9, 2011 10:13 AM
During the charging procedure, the handle of the machine warms up. This is nor-
mal.
Disconnect the battery charger from the mains supply when not using it for long-
er periods.
Protect the battery charger against moisture!
Observe the notes for disposal.
Changing the Tool (see figures B1
– Secure the lock-off button 2.
– Rotate the blade 4 with a screwdriver until one of the holes in the blade is free
(uncovered).
– Insert a thin, sturdy object (e.g., a nail) into the free hole, to block the blade.
– Unscrew the blade screw 11.
– Remove the object with which you blocked the blade.
– Slightly lift off the blade and pull it out towards the bottom.
– Attach the new blade onto the tool holder ensuring that the ground edge of the
blade faces you.
Pay attention that the blade engages onto the tool holder.
– Tighten the blade screw again.
Operation

Starting Operation

Switching On
– Release the lock-off button 2.
– To start the machine, press the On/Off switch 1 and keep it pressed.
Switching Off
– To switch off the machine, release the On/Off switch 1.
– Afterwards, secure the lock-off button 2 again.

Working Advice

Do not strain the machine so heavily that it comes to a standstill.
The cutting performance of the machine depends on the materials to be cut and
on the charging condition of the battery.
Depending on the charge condition of the battery, excessive feed considerably
reduces the performance capability.
Always keep the blade free and clean of material remainders.
The guide edge 5 may not become wedged during cutting and must be aligned
parallel to the cutting surface.
Improper use will make the blade dull.
Thin materials, such as fabrics, can be pulled into the machine during cutting and
become wedged. Therefore, do not apply too much pressure with such materials
in order to achieve good cutting results. During cutting, apply sufficient tension
while holding fabrics and cut slowly.
Optimum cutting results are best determined through practical testing.
Overload Protection
When the load on the machine is too high, the battery charge-control indicator 7
flashes red and the power tool switches off automatically.
– To start the operation of the machine again, relieve the load on the power tool
first and then switch on again (press ON/OFF switch 1).
The battery charge-control indicator lights up green again.
"Cut Control" Cutting-line Mark
The red line on the blade guard ("Cut Control" cutting-line mark 6) indicates the
cutting line of the blade 4.
Bosch Power Tools
English | 21
B3)
–
1 609 929 W36 | (9.8.11)