Starting Operation - Bosch Cutter Originalbetriebsanleitung

OBJ_BUCH-2057-003.book Page 19 Thursday, January 29, 2015 9:39 AM
Dismounting (see figures B1–B2)
– Turn the release ring 4 in rotation direction  and pull the cutting
adapter off toward the front ().
– Afterwards, mount the rubber cap 9 onto the screwdriver again.
Changing the Blade (see figures C1–C2)
Note: Replace the blade only when the cutting adapter is mounted on the
screwdriver. This ensures that the tool spindle is locked and the blade
screw can be loosened.
– Set the rotational direction switch 5 to the middle position.
– Unscrew the blade screw 7 in rotation direction .
– Lightly lift the blade 8 and pull it down and out.
– Attach the new blade onto the tool holder ensuring that the ground
edge of the blade faces you.
Pay attention that the blade engages onto the tool holder.
– Retighten the blade screw 7 in rotation direction .
Operation

Starting Operation

To save energy, only switch the power tool on when using it.
Reversing the rotational direction
IXO (3 603 JA8 0..) (see figure D1)
– To set right rotation on the screwdriver, slide the rotational direction
switch 5 all the way forward.
IXO (3 603 J81 0.., 3 603 J59 3..) (see figure D2)
– To set right rotation on the screwdriver, press the rotational direction
switch all the way in from the right.
Switching On and Off
– To start the cutting adapter, press the On/Off switch 6 of the screw-
driver and keep it pressed.
– To switch off the cutting adapter, let go of the On/Off switch 6 of the
screwdriver.
Bosch Power Tools
English | 19
1 609 92A 10G | (29.1.15)