Operation Of The Unit - Klauke K 19 Bedienungsanleitung

Instruction manual K 19
___________________________________________________________________________

3.1. Operation of the unit

First you have to select the right dies (Pos.-No. 6) for the intended application.
The crimping head has to be opened by pulling out the locking pin (Pos.-No. 3).
Afterwards the dies will be inserted consecutively into the crimping head. Then the
crimping head must be closed again.
The necessary hand forces can be adjusted with the telescope handles. To do that you
have to loosen the screws (Pos.-No. 2), pull them out and fix them again.
The crimping process is defined by the closing motion of the dies. During that process
the connecting material is positioned in the stationary half of the die whereas the moving
part of the die is approaching the compression point.
A crimping process is terminated when the dies contacted. After the crimping process has
been finished the latch (Pos.-No. 1) has to be opened again and the connecting material
has to be removed.
3.2. Explanation of the application range
Our mechanical crimping tool type K 19 has a various dies (Pos.-No. 6) available to
crimp copper, aluminium and other connecting material according to the determined use.
Instruction manual K 19
___________________________________________________________________________
3.1. Operation of the unit
First you have to select the right dies (Pos.-No. 6) for the intended application.
The crimping head has to be opened by pulling out the locking pin (Pos.-No. 3).
Afterwards the dies will be inserted consecutively into the crimping head. Then the
crimping head must be closed again.
The necessary hand forces can be adjusted with the telescope handles. To do that you
have to loosen the screws (Pos.-No. 2), pull them out and fix them again.
The crimping process is defined by the closing motion of the dies. During that process
the connecting material is positioned in the stationary half of the die whereas the moving
part of the die is approaching the compression point.
A crimping process is terminated when the dies contacted. After the crimping process has
been finished the latch (Pos.-No. 1) has to be opened again and the connecting material
has to be removed.
3.2. Explanation of the application range
Our mechanical crimping tool type K 19 has a various dies (Pos.-No. 6) available to
crimp copper, aluminium and other connecting material according to the determined use.
page 11
page 11