Attaching The Headrest - Leckey Squiggles Bedienungsanleitung

Attaching the
push handle
The push handle is attached to both the
Hi low chassis and the Easy chassis by
inserting the two lower stems into the
receiving tubes as shown. The push handle
has safety poppers, which need to be pressed
in when inserting the lower stems. On the
Hi low chassis push the stems in until the
poppers protrude from the other end of
the receiving tubes.
On the Easy chassis the poppers will engage
in holes in the receiving tubes. Once inserted
secure the push handle by tightening the two
plastic hand knobs (A) underneath.
Check the knobs are tight before you move
the product, particularly if you are moving
the seat unit along corridors that may have
uneven or sloping surfaces.
A
A
Attaching the
headrest
To attach the Leckey headrest slide the stem
into the receiving bracket on the backrest, set
to the desired position and secure using the
plastic ratchet handle.
The Squiggles Seating System has been
designed to interface with Whitmyer head
supports. The Whitmyer Lynx headsupport
is attached in the same way as the Leckey
headrest. To attach Whitmyer Pro-Series
headsupports remove the spacer collar from
the receiving bracket and lock the vertical
stem in position using the ratchet handle.