Babyphon Easy Control 200_ 10-2013 Seite 14 Mittwoch, 23. Oktober 2013 2:06 14
4. Turn on the parent unit 7 by pressing the
on/off button 8 for 3 seconds:
– The parent unit 7 will now seek out a
radio connection with the baby unit 13.
Whilst it is doing this, the range
indicator 3 will flash.
– As soon as the radio connection is
established, the range indicator 3 will
give off a constant light.
5. As soon as your baby makes any noise,
the sound indicator 1 will flash more
rapidly and you will be able to hear the
noises through the speaker 11.
6. You can increase and decrease the
volume using buttons 9 and 10 .
Note:
– a double beep will sound at the end of
the adjustment range.
– the volume cannot be decreased to
'zero'.
7.1 Cleaning
Warning! To avoid the risk of
electric
shocks,
damage:
– Always disconnect the mains
adapter from the power socket
before cleaning the device.
– Never immerse the individual
parts in water.
Caution! Under no circumstances use
abrasive, corrosive or scratching cleaning
agents, as these could damage the device.
1. If necessary, wipe the individual parts
with a damp cloth.
2. Only use the baby monitor again when all
the parts have fully dried out.
Note:
• Where the batteries are new and fully
charged, the parent unit 7 can be
disconnected from the mains adapter
and operated on a portable basis for up
to 6 hours.
• The charging indicator 2 flashes quickly
(approx.
batteries are almost empty.
• There is no warning when the batteries
are completely empty. You should
therefore regularly check the connection.
• If you and the parent unit 7 move too far
from the baby unit 13, a warning will
appear:
– The range indicator 3 will begin to
– If it is unable to establish a new
7. Cleaning and care
injuries
and
14
every
second)
flash. The parent unit 7 will try to re-
establish its connection with the baby
unit 13.
connection within 20 seconds, the
parent unit 7 will emit a warning in the
form of double beeps. You should then
move closer to the baby unit 13.
when
the