Mains Adapter; Setting Up The Power Supply; Baby Unit; Operating The Device - NUK Easy Control 200 Bedienungsanleitung

Babyphon Easy Control 200_ 10-2013 Seite 13 Mittwoch, 23. Oktober 2013 2:06 14

4.2 Mains adapter

Input:
Output:
Protection class:

5. Setting up the power supply

5.1 Parent unit
1. Remove the belt clip 4 by sliding it
downwards.
2. Open the battery compartment by sliding
the cover 6 downwards.
3. Place both the batteries supplied with the
device inside the battery compartment.
Note: When inserting the batteries make
sure that the polarity (+/–) is correct. The
correct polarity is engraved inside the
battery compartment.
4. Close the battery compartment.
5. Reattach the belt clip 4.
6. Insert a mains adapter jack into the
connector socket 5.
7. Plug the mains adapter into a power
socket that conforms to the technical
data (see "4. Technical
page 12).
1. Position the baby unit 13 somewhere in
the nursery where your baby will not be
able to reach it.
Warning! For your child's safety:
make sure that the mains cable is
out of your baby's reach (risk of
strangulation).
Radio waves:
– During normal operation, the baby unit
interrupts transmission as soon as your
child is quiet. Both units then simply
carry out connection checks at regular
intervals.
100 - 240 V~ / 50/60 Hz / 0.15 A
5 V DC / 0.6 A
II

5.2 Baby unit

The baby unit 13 doesn't need batteries.
1. Insert the jack of the second mains
2. Plug the mains adapter into a power
data" on

6. Operating the device

2. Insert a mains connector jack into the
3. Plug the mains adapter into a power socket
13
The batteries in the parent unit 7 will then
start to charge. Charging the batteries
completely will take
15 hours.
Note: As a very low current is used to
charge the batteries, the mains adapter
can remain constantly plugged in without
this damaging the batteries. As a result,
the parent unit 7 will be ready for mobile
use at any time.
adapter into the connector socket 12.
socket that conforms to the technical
data (see "4. Technical
page 12).
The baby unit 13 is now ready for use.
The mains adapter indicator 14 is
illuminated.
– To keep your child's exposure to
radiation as low as possible, you
should ensure that a minimum distance
of at least 1 m is maintained between
your child and the baby unit.
connector socket 12 of the baby unit 13.
that conforms to the technical data (see
"4. Technical data" on page 12).
The baby unit 13 is now ready for use.
The mains adapter indicator 14 is
illuminated.
approximately
data" on