Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Press the power button
the speaker to standby mode.
•
Activate BT on your mobile device. Search for BT devices in your area and pair with Light-Up. If you're
prompted to enter a password, please type in "0000".
•
The Light Up will make a beep sound upon successful connection.
•
The Light Up will auto reconnect the previous paired device when it enters into BT mode. If the unit
doesn't auto connect with the previous paired device, please restart the BT in the smartphone/tablet
and then follow the above steps to finish the connection.
•
You can manually turn of BT for your smartphone/tablet; BT connection will also be cancelled in case
the smartphone/tablet is too far away from the Light Up (over 10m). in this latter case, the unit will go
back to BT standby mode.
•
To reconnect, please ensure that BT on your smartphone is set at the 'searching device' mode. Keep
pressing 'pairing' until you find the Light Up again, and follow the above steps.
Use the supplied 3.5mm audio cable to connect external audio players with the Light Up. Press MODE re-
peatedly to change to AUX mode. Use the external player to playback audio.
•
USB port for charging
•
USB power output DC 5V~0.5A. It supports charging all devices in the power range.
•
When charging a device, ensure that the power supply is the right one for your device.
•
Charging function is ok under OFF/ BT/ Aux in mode
•
USB/SD for MP3 playback
•
Power on the unit and insert a USB Flash Drive (not supplied) into the USB Port, ensuring the plug
is fully inserted in the correct way. The tower will play music from the USB automatically. The
maximum size of the Flash Drive that can be supported is up to 32GB.
•
Insert an Micro SD card (not supplied) into the memory card expansion slot. Make sure it is in-
serted in the correct way. The tower will play music from the Micro SD card automatically. The
maximum size of the Flash Drive that can be supported is up to 32GB.
REMARK: When both USB and SD card are inserted, pressing the play button for a long time can swap
between USB and SD card.
14
Operation
once to switch on the tower speaker. Press the power button again to switch off
BT: Pairing
USB/SD
AUX
Werbung
Inhaltsverzeichnis
