Ferm SGM1011 Übersetzung Der Originalbetriebsanleitung Seite 8

EN
back in the paint box.
• Remove the paint residu from the container,
using a brush or cloth.
• Pour solvent or water, depending on the type
of paint used, in the container and screw it
back on the spray gun. WARNING: Only use
solvents with a flash point less than 55º C.
• Switch the machine on.
• Press the trigger and spray until only clean
water or solvent is coming out of the nozzle.
• Switch off the machine.
• Unscrew and dry the container. Make sure
also to clean and dry the surface and the seal.
Make sure there is no paint residu left.
• Wipe the exterior of the spray gun with a cloth
dampened with water or solvent.
• Unscrew the nut and dismantle the nozzle.
Clean all part thoroughly in water or solvent.
Do not use sharp metal objects for cleaning!
• Re­assemble the spray gun.
Changing the air filter.
• Remove the cover by lifting it with a
screwdriver.
• Remove the old air filter.
• Place the new filter with the smooth side
towards the machine.
• Place the cover back onto the machine.
Never operate the machine without the air filter
installed. Dirt could enter the machine and
interfere with the function of the machine.
lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is
an exhaustive overview of the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
8
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that
purpose.
Warranty
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.