Bosch GCM 10 J Professional Originalbetriebsanleitung Seite 33

Integrated Dust Extraction (see figure C)
For basic dust collection, use the dust bag 21
provided.
– Press the clip of the dust bag 21 together
and slide the dust bag over the saw dust
ejector 25. The clip must engage into the
groove of the saw dust ejector.
During sawing, the dust bag must never come in-
to contact with the movable machine parts.
Always empty the dust bag in good time.
Check and clean the dust bag each time af-
ter using.
When sawing aluminium, remove the dust
bag to avoid the risk of fire.
External Dust Extraction
For dust extraction, a vacuum hose (size
Ø 36 mm) can also be connected to the dust
ejector.
– Connect the vacuum hose with the sawdust
ejector 25.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Changing the Tool (see figures E1
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation in-
structions and that are tested and marked in ac-
cordance with EN 847-1.
Use only saw blades recommended by the tool
manufacturer, and suitable for sawing the mate-
rials to be cut.
Bosch Power Tools
Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Press lever 1 and swing back the retracting
blade guard 4 to the stop.
Hold the retracting blade guard in this posi-
tion.
– Loosen the screw 32 with the Phillips screw-
driver 28 provided until the fastening ele-
ment of the retracting blade guard can also
be swung to the rear to the stop.
– Turn the Allen screw 34 with the Allen key 28
provided while at the same time pressing the
spindle lock 33 until it engages.
– Hold the spindle lock 33 pressed and un-
screw the Allen screw 34 in clockwise direc-
tion (left-hand thread!).
– Remove the clamping flange 35.
– Remove the saw blade 36.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Place the new saw blade onto the tool spin-
dle 37.
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
E3)
–
the blade guard!
– Place on the clamping flange 35 and the Allen
screw 34. Press the spindle lock 33 until it
engages and tighten the screw turning in an-
ticlockwise direction.
– Push the retracting blade guard 4 down to-
ward the front until Phillips screw 32 engag-
es in the corresponding recess.
For this, it is possible that you must counter-
hold the tool arm by the handle, to achieve
the pre-tension of the retracting blade guard.
– Fasten the retracting blade guard 4 again
(tighten screw 32).
– Press lever 1 and guide the retracting blade
guard down again.
English | 33
1 609 929 W04 | (11/2/10)